Driven Media Tail Light Turn Signal Overlay 2022-2026 WRX

Here, you are looking at the Driven Media Tail Light Turn Signal Overlay for the 2022+ WRX!

OEM 2022+ WRX tail lights utilize a clear section that contrasts the red of the brake light. These tail light overlays allow you to completely transform the look of the rear end by blending that section into the rest of the black accents on the tail lights and trunk giving you an aggressive and sleek appearance while still allowing your lights to shine brightly through.

These overlays are designed and cut in-house using high-quality vinyl to ensure proper fit and finish.

Installation Instructions: (Dry Application - Dark Smoke and Light Smoke)

• Note: The front of the overlays is indicated by the location of the “L” and “R” so make sure to pay attention to the orientation.

• Prior to applying the overlay, make sure the surface is thoroughly cleaned and dry.

• Carefully peel the overlay off of the backing and use the bottom edge of the headlight to line it up to cover the orange sidemarker. There is a line in the lens of the headlight that is approximately 1/4” away from the edge that you can use as a guide.

• Once you have successfully positioned the overlay where you want it, use a vinyl squeegee or microfiber to remove any air bubbles.

• We recommend allowing at least 48hrs before washing the car to allow for the adhesive to cure and avoid directly spraying them with a pressure washer.

• The temperature needs to be a minimum of 65°F for proper application.

Installation Instructions: (Wet Application - Red and Yellow)

• Prior to applying the overlay, make sure the surface is thoroughly cleaned.

• Carefully peel the overlay off of the backing. (Each overlay is marked left or right on the backing sheet.)

• Spray the surface of the lens and the overlay with soapy water. (Dawn Soap recommended, just need a drop or two)

• Position the overlay on the lens using the edges of the tail light to guide you. The overlays were designed to have the slightest overlap(thickness of your nail) into the black area of the surrounding tail light area to make installation easier so keep this in mind while installing them.

• Once you have successfully positioned the overlay where you want it, use a vinyl squeegee or microfiber to remove any air/water bubbles.

• We recommend allowing at least 48hrs before washing the car to allow for the adhesive to cure and avoid directly spraying them with a pressure washer.

• The temperature needs to be a minimum of 65°F for proper application.